Education
2002–2005 DeVry University West Hills, CA
B.S. Electronic Engineering Technology.
3.45 cumulative GPA.
Professional Experience
Integration Engineer 06/2012 - Current Blue Origin WTLS Van Horn, TX
Rocket engine test stand system integration
Electrical sensor and control installation and troubleshooting
Mechanical system installation and development
Fabrication for expansion and reconfigurations
Perform Test Operations
Lab Manager 2006-2012 Convergence Engineering Gardnerville, NV
Execute laboratory engineering tests
Operate data acquisition system, and run test sequences in
laboratory and field environments
Design and fabrication of test structures for lab testing
Project management
Computer and network maintenance
Design, fabricate, and verify low and high-pressure systems.
FEA analysis with ANSYS
Major Test Projects
Tested composite duct for the Joint Strike Fighter
Fabricated test structure and designed control system for tests
Conducted testing and post processing of data
Structural testing for Top Fuel NHRA drag car and funny cars frames
Trackside testing of multiple Top Fuel drag car chassis
Comparison testing of Top Fuel chassis in lab vs. track
Testing of prototype landing gear leg
Design and fabrication of complex test system with
Design of high speed, High force computer controlled hydraulic
system to meet stringent simulation test requirements
Conducted multiple high force level impact tests.
Rocket Engine Test Stand support
Integrated Engine supply lines and electrical lines for test stand
Worked in cryogenic hazard test area
Built test structure to test spray pattern of rocket engine injector
Material characterization testing, from plastics to exotic metals
Major FEA Projects
FEA analysis types include: Static and dynamic structural analysis
modal analysis, acoustic analysis, and thermal analysis.
Radomes
Vertical Axis Wind Turbine (VAWT) components
Optical benches
Rocket injectors and injector test chamber housings
drilling rigs and components
Automotive racing components
Electronic Tech II 2005 Electro rent Van Nuys, CA
Tested and calibrated power supplies, electronic loads, etc.
Troubleshot and repaired units at electronic component level
Worked with 110V, 220V, 440V, single and 3 phase line voltages.
Electronic Tech 2005 Antelope Valley Microwave Lancaster, CA
Assembly and test of RF circuits for F16 Radar Systems
Power amplifiers, Multipliers, Attenuators, etc.
Set chips, and connections under a microscope
Operated gold wedge wire bonder, and ribbon bonder
Clean room environment
Special Skills
FEA modeling: build, solve, and post-process with ANSYS
Welding (TIG, MIG, stick, and Oxyacetylene)
Machining (program G-code, manual or ...
Login or Register to view the full resume.
